What is a Parapet Wall?

A common roofing feature seen in many flat roofing projects is the parapet wall. It is commonly an extension of the wall cavity projecting above the flat roof and can vary in height and width according to its designed function.

It is usual to find coping stones dressed across the top of the cavity and extending internally and externally to create a drip relief away from the vertical wall faces.

Where Are Parapet Walls Installed?

During a flat roof installation, particularly on a new build, two main specifications are available:

  1. Encapsulation: this involves the construction of a parapet in timber, typically 18mm OSB 3 Board, brick or block work that is either rendered or again overboarded with timber. The next stage involves the selection and installation of a flat roofing material that will extend from the roof deck onto the vertical internal parapet face via a preformed angle fillet and would finish with a preformed drip edge to the outside face.
  2. Encapsulation with Coping Stones: The flat roof parapet material installation is completed as in general encapsulation but with the omission of the external drip edge. The selected coping stone may then be secured to the top of the parapet area.

Benefits of both applications described eliminate the need for lead flashings which are costly, prone to theft and, if incorrectly fitted, can be a source of leaks.

Additionally, both procedures reduce the risk of water ingress through failed coping stone joints and into cavities. Remember, the top of the parapet structure has already be sealed.
This also applies to architectural aluminium capping where failed seams result in unsightly mastic repair joints that often fail a second time.

Benefits of Installing a Parapet Wall

Eliminate lead flashing: parapet wall installation omit the necessity for lead flashings, which are prone to theft, create additional cost and in some cases are a common cause of flat roofing leaks. Parapets reduce cost and cannot be stolen like lead flashings. Another reason is that they eliminate a common source of flat roofing leaks, preventing water ingress through any failed joints in the coping stones.

Eliminates aluminium coping: parapets also work well with architectural aluminium coping, which can suffer from leaking joints and often require unsightly mastic repair seals.

Simpler installation: parapet walls are also faster, simpler and cheaper to install than other features like lead flashing, which is particularly beneficial when tight building project deadlines are required. 

Which Material is Best For a Parapet Wall?

A range of materials can be used to construct parapet walls. The seamless and joint free nature of a fibreglass installation makes this the favoured procedure for modern parapet waterproofing. Due to its design, it often becomes a natural extension of the roof and can offer a simulated lead effect. However, single ply is also a popular option, but should ideally be combined with polyurethane resins in hard to reach areas (angles, joints and intersections) to mitigate leaks. 

The methods described here for providing weather protection to parapet walls provide faster, less expensive solutions which are particularly beneficial when tight project deadlines are required.

Contact a Flat Roofing Specialist

If you need any further advice on parapet wall coatings, look no further. At Strandek Flat Roofing, we’ve been installing parapet walls and flat roofs since 1976. If you’d like a no obligation quote, give us a call on 02921 900011 or send us an enquiry.

Leave a Reply

Your email address will not be published. Required fields are marked *